One kilobyte KB is equal to 1, bytes or characters; KB indicates , bytes or characters. Bit-mapped register setup To set the register, see instructions for S13 Bit. USRobotics warrants the media containing software against failure during the warranty period. Life in the slow lane: The receiving modem compares its results with the received. This equipment is supplied with a suitable PSTN connector for the country in which it was supplied.

Uploader: Dajind
Date Added: 23 May 2018
File Size: 48.42 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 71553
Price: Free* [*Free Regsitration Required]

When the implied warranties professioanl not allowed to be excluded in their entirety, they will be limited to the duration of the applicable written warranty.

3com U.s. Robotics 56k Professional Message Modem | eBay

Data is transmitted between the devices over a shielded serial cable with a pin male DB connector to the modem and a pin, 9-pin, 8-pin, or custom-built connector to the computer. The pause is set in 10 millisecond intervals.

The computer professional software will use these settings until changed by the user or other software. Select Install one of the other driversthen click Next.

Windows XP users must be in administrator mode to properly add any new hardware. Either the same type of parity must be used by two communicating computers, or both may omit parity.

The faxes will continue to be forwarded until the feature is disabled. Blinking rapidly indicates that self-memory is full. Caller ID must be subscribed from your telephone provider before this feature can be utilised.


See S-register S0 in the “Technical Reference” section. To access your voice messages remotely, you need to dial into the 56K Message Modem. These factory default settings should be sufficient for most users.

If this is the case and you are not sure how to properly configure your COM ports, contact your computer manufacturer. All products that are replaced will become the property of USRobotics. You must exit out of the PhoneTools application to be able to access messages remotely. Bit-mapped register setup To set the register, see the instructions for S13 Bit. Sets the duration, in minutes, for the inactivity timer The timer activates when there is no data activity on the phone line; at time-out the modem hangs up.

The repaired or replaced item will be shipped to Customer, at U. Your product number is B. Click the Device Manager tab. Make sure the modem is turned on and that the power supply is connected between the modem and the electrical outlet. Click Startselect Settingsthen click Control Panel. These protocols are in the public domain and are available from many bulletin board services. Make sure the port you are plugging the modem into appears in the list.


Sets the number of rings on which to answer in Auto Answer Mode. Write down your new USRobotics modem’s serial number, which is located on the white bar code sticker on the modem and on the modem’s box.

3com U.s. Robotics 56k Professional Message Modem

Life in the slow lane: Use alone to test for OK result code. Plug the power supply into the jack on the modem and the other end into an electrical outlet.

This option only applies to connections terminated by dropping DTR.

Mobile by Morgan Little Oct 26, Windows NT users must be in administrator mode to properly add any new hardware. Phones by Shara Tibken Oct 25, This command terminates with OK when either the specified amount of silence is detected or when the user types anything which is ignored.

Customer assumes responsibility for the selection of the appropriate applications program and associated reference materials.

The first time that you connect with your service provider, the modem will perform the full training sequence and store the information it receives.